We gratefully acknowledge support from
the Simons Foundation and member institutions.

Instrumentation and Detectors

New submissions

[ total of 9 entries: 1-9 ]
[ showing up to 2000 entries per page: fewer | more ]

New submissions for Wed, 29 Jan 20

[1]  arXiv:2001.10036 [pdf, other]
Title: Counting Statistics of Single-Photon Avalanche Diodes
Comments: 10 pages, 4 figures
Subjects: Instrumentation and Detectors (physics.ins-det); Optics (physics.optics); Quantum Physics (quant-ph)

This work presents stochastic approaches to modeling the counting behavior of single-photon avalanche diodes (SPADs). We present both analytical expressions and simulation algorithms predicting the distribution of the number of detections in a finite time window. We also present formulas for the mean detection rate. The approaches cover recovery time, afterpulsing, and twilight pulsing. We experimentally compare the theoretical predictions to measured data using commercially available silicon SPADs. Their total variation distances range from $10^{-5}$ to $10^{-2}$.

[2]  arXiv:2001.10132 [pdf, other]
Title: An analysis and visualization of the output mode-matching requirements for squeezing in Advanced LIGO and future gravitational wave detectors
Comments: Submitted to PRD
Subjects: Instrumentation and Detectors (physics.ins-det); Instrumentation and Methods for Astrophysics (astro-ph.IM)

The sensitivity of ground-based gravitational wave (GW) detectors will be improved in the future via the injection of frequency-dependent squeezed vacuum. The achievable improvement is ultimately limited by losses of the interferometer electromagnetic field that carries the GW signal. The analysis and reduction of optical loss in the GW signal chain will be critical for optimal squeezed light-enhanced interferometry. In this work we analyze a strategy for reducing output-side losses due to spatial mode mismatch between optical cavities with the use of adaptive optics. Our goal is not to design a detector from the top down, but rather to minimize losses within the current design. Accordingly, we consider actuation on optics already present and one transmissive optic to be added between the signal recycling mirror and the output mode cleaner. The results of our calculation show that adaptive mode-matching with the current Advanced LIGO design is a suitable strategy for loss reduction that provides less than 2% mean output mode-matching loss. The range of actuation required is +47 uD on SR3, +140 mD on OM1 and OM2, +50 mD on the SRM substrate, and -50 mD on the added new transmissive optic. These requirements are within the demonstrated ranges of real actuators in similar or identical configurations to the proposed implementation. We also present a novel technique that graphically illustrates the matching of interferometer modes and allows for a quantitative comparison of different combinations of actuators.

[3]  arXiv:2001.10145 [pdf]
Title: A multi-stop time-of-flight spectrometer for the measurement of positron annihilation-induced electrons in coincidence with the Doppler-shifted annihilation gamma photon
Comments: The following article has been submitted to Review of Scientific Instruments. After it is published, it will be found at this https URL
Subjects: Instrumentation and Detectors (physics.ins-det); Materials Science (cond-mat.mtrl-sci)

Here we describe an advanced multi functional, variable-energy positron beam system capable of measuring the energies of multiple positron-induced electrons in coincidence with the Doppler-shifted gamma photon resulting from the annihilation of the correlated positron. The measurements were carried out using the unique characteristics of the digital time-of-flight spectrometer and the gamma spectrometer available with the advanced positron beam system. These measurements have resulted in (i) the first digital time of flight spectrum of positron annihilation-induced Auger electrons generated using coincident signals from a high-purity Ge detector and a micro-channel plate; (ii) a two-dimensional array of the energy of Doppler-broadened annihilation gamma and the time of flight of positron-annihilation induced Auger electrons or secondary electrons measured in coincidence with the annihilation gamma photon; and (iii) the time of flight spectra of multiple secondary electrons ejected from a bilayer graphene surface as a result of the impact and(or) annihilation of positrons. The novelty of the gamma electron coincidence spectroscopy has been demonstrated by extracting the Doppler-broadened spectrum of gamma photons emitted due to the annihilation of positrons exclusively with 1s electrons of carbon. The width of the extracted Doppler-broadened gamma spectrum has been found to be consistent with the expected broadening of the annihilation gamma spectrum due to the momentum of the 1s electrons in carbon.

[4]  arXiv:2001.10224 [pdf, other]
Title: Second generation of portable gamma camera based on Caliste CdTe hybrid technology
Comments: 6 pages, 7 figures
Subjects: Instrumentation and Detectors (physics.ins-det); Medical Physics (physics.med-ph)

In the framework of a national funded program for nuclear safety, a first prototype of portable gamma camera was built and tested. It integrates a Caliste-HD CdTe-hybrid detector designed for space X-ray astronomy coupled with a new system-on-chip based acquisition system (FPGA and ARM microprocessor) and thermo-electrical coolers for a use at room temperature. The complete gamma part of the camera fits in a volume of 15 x 15 x 40 cm^3 for a mass lower than 1 kg and a power consumption lower than 10 W. Localization and spectro-identification of radionuclides in a contaminated scene were demonstrated during several test campaigns. A new generation of system is under development taking into account feedback experience from in-situ measurements and integrating a new generation of sensor cost-optimized by industrial applications called Caliste-O. Caliste-O holds a 16 x 16 pixel detector of 14 x 14 mm^2 and 2 mm thick with 8 full-custom front-end IDeF-X HD ASICs. Two prototypes were fabricated and tested. The paper will present the results of in-situ measurements with the first gamma camera, the spectroscopic performance of Caliste-O and the design of the second generation of gamma camera which aims for real time imaging and spectro-identification.

[5]  arXiv:2001.10322 [pdf, other]
Title: Characterisation of SiPM radiation hardness for application in hadron calorimeters at FAIR, CERN and NICA
Comments: Prepared for submission to JINST
Subjects: Instrumentation and Detectors (physics.ins-det); High Energy Physics - Experiment (hep-ex)

Silicon PhotoMultipliers (SiPM) are an excellent choice for the scintillator light readout at hadron calorimeters due to their insensitivity to magnetic fields, low operating voltages, low cost, compactness and mechanical endurance. They are already successfully utilized in Projectile Spectator Detector (PSD) of NA61 at CERN, and will be utilized soon in PSD of CBM at FAIR and Forward Hadron CALorimeters (FHCAL) of BM@N at NICA heavy-ion collision experiments. The main issue of SiPM application is their degradation due to high neutron fluence that can reach up to 2E11 neq/cm2 per year of the experiment operation. Multiple irradiation tests of SiPMs produced by Ketek, Zecotek, Hamamatsu and Sensl manufacturers were conducted at the cyclotron of NPI Rez with a broad neutron spectrum and total fluences in the wide range of 5E10 - 6E12 neq/cm2. Detailed characterisation of all SiPMs was performed based on dependencies of dark current on voltage, capacitance on voltage and frequency, and response to LED light on voltage. SiPM's breakdown voltage, quenching resistance, pixel capacitance, gain and signal to noise ratio were extracted from these measurements. Those parameters' dependence on neutron fluence and their variability are discussed. Performance of the PSD calorimeter module equipped with irradiated SiPMs in CERN during the beam scan with 2 - 80 GeV/c protons is briefly overviewed.

[6]  arXiv:2001.10446 [pdf, other]
Title: Studies on tetrafluoropropene-based gas mixtures with low environmental impact for Resistive Plate Chambers
Comments: 15th Topical Seminar on Innovative Particle and Radiation Detectors (IPRD19)
Subjects: Instrumentation and Detectors (physics.ins-det)

Gaseous detectors are widely used in high-energy physics experiments, and in particular at the CERN Large Hadron Collider (LHC), to provide tracking and triggering over large volumes. It has been recently estimated that Resistive Plate Chambers (RPC), used for muon detection, have the highest contribution on the overall greenhouse gas (GHG) emissions at the LHC experiments.
Gas mixtures for RPCs are mainly made of C$_{2}$H$_{2}$F$_{4}$, which is a greenhouse gas with a high environmental impact in the atmosphere. C$_{2}$H$_{2}$F$_{4}$ is already phasing out of production, due to recent European Union (EU) regulations, and its cost is expected to increase in the near future. Therefore, finding alternative gas mixtures made of gas components with a low Global Warming Potential (GWP) has become extremely important for limiting the GHG emissions as well as for economic reasons.
The novel hydrofluoroolefins are likely appropriate candidates to replace C$_{2}$H$_{2}$F$_{4}$ due to their similar chemical structures. This study is focused on the characterization of innovative gas mixtures with tetrafluoropropene HFO1234ze(E) (C$_{3}$H$_{2}$F$_{4}$) that is one of the most eco-friendly hydrofluoroolefins, thanks to its very low GWP. HFO1234ze(E)-based gas mixtures with the addition of Ar, N$_{2}$, O$_{2}$ and CO$_{2}$ are extensively discussed in this paper as well as the role of i-C$_{4}$H$_{10}$ and SF$_{6}$ in such mixtures.

Cross-lists for Wed, 29 Jan 20

[7]  arXiv:2001.10041 (cross-list from nucl-ex) [pdf, other]
Title: A New Neutron Lifetime Experiment with Cold Neutron Beam Decay in Liquid Helium
Authors: Wanchun Wei
Subjects: Nuclear Experiment (nucl-ex); Instrumentation and Detectors (physics.ins-det)

The puzzle remains in the large discrepancy between neutron lifetime measured by the two distinct experimental approaches -- counts of beta decays in a neutron beam and storage of ultracold neutrons in a potential trap, namely, the beam method versus the bottle method. In this paper, we propose a new experiment to measure the neutron lifetime in a cold neutron beam with a goal sensitivity of 0.1% or sub-1 second. The neutron beta decays will be counted in a liquid helium scintillation detector at 0.5 K, and the neutron flux will be simultaneously monitored by the helium-3 captures in the same volume. The cold neutron beam must be of wavelength $\lambda>16.5~\r{A}$ to eliminate scattering with liquid helium.

[8]  arXiv:2001.10211 (cross-list from astro-ph.IM) [pdf, ps, other]
Title: Simulating the JUNO Neutrino Detectors
Authors: Srikanta Sinha
Comments: 11 pages, 4 figures
Subjects: Instrumentation and Methods for Astrophysics (astro-ph.IM); High Energy Physics - Experiment (hep-ex); Instrumentation and Detectors (physics.ins-det)

The JUNO neutrino detector system is simulated using Monte-Carlo and analytical methods. A large number of proton decay events are also simulated. Preliminary results from this endeavor are presented in the present article.

Replacements for Wed, 29 Jan 20

[9]  arXiv:1909.11120 (replaced) [pdf, other]
Title: Feasibility study of a compact Neutron Resonance Transmission Analysis instrument
Journal-ref: AIP Advances (2020)
Subjects: Instrumentation and Detectors (physics.ins-det)
[ total of 9 entries: 1-9 ]
[ showing up to 2000 entries per page: fewer | more ]

Disable MathJax (What is MathJax?)

Links to: arXiv, form interface, find, physics, recent, 2001, contact, help  (Access key information)